--------------------------
notepad laser engraved decoration

Give a simple notebook
a personal touch

Step by step guide

準備

Required material
  • Leuchtturm1917® Sketchbook Master (A4+), Hardcover - emerald
  • Leuchtturm1917® Jottbook Medium (A5) - navy
  • Spray glue
  • Piece of paper - the more contrasting, the better
Used Trotec Laser
  • Speedy 400
  • 80 watts
  • 2 inch lens

ステップ・バイ・ステップ

laser cut and engraved notebooks
ステップ 1

Step 1: Laser engraving the sketchbook

The sketchbook was refined with a fine engraving and personalized with a name. Open the PDF design and enter your chosen name. As always, you can also use your own design.

Parameters used:

The following parameters produce a brown engraving on the emerald sketchbook:
Engraving: Power: 20% - Speed: 30% - Frequency: 500 ppi - Air Assist: ON - Z-Offset: -1 mm

Note:

Other colors may react differently.

ステップ 2

Step 2: Laser cutting the notebook

The Jottbook has a flexible cover that can be easily cut with a laser. We have created a tree design for our notebook. To give more stability to the fine details, we've glued a piece of paper on the inside of the cover after the laser process.

1: table
Use the Aluminum Cutting Grid Table and cover the surface around the workpiece to focus the vacuum suction.

2: air flow shutter
If using an air flow shutter, please close it to achieve optimal suction on the table and not on the exhaust slots.

3: laser process
Open the design and send it to the laser.

Parameters used:

Cutting: Power: 20% - Speed: 0.5% - Frequency: 1000 Hz - Air Assist: OFF -
Z-Offset: -1 mm

lasercut notebook cover inside
ステップ 3

Step 3: Finishing

Take a piece of paper that fits to your design and a spray glue. Glue the paper on the inside of the cover to protect your laser cut design and give the cover more stability. You could also use a glue stick, but the spray glue helps to achieve maximum coverage.

Speedyシリーズ
名入れに最適なレーザー加工機です。

レーザー加工機のご紹介

レーザーの用途や設定に関するご質問はありますか?
喜んでアドバイス致します

お問い合わせ
会員 troGROUP Logo