Lasermade Jewellery
Necklace with Laser-Cut Pendant

This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.

acrylic pendant laser cutting


Required material
  • TroLase Reverse gloss/gold 1.6mm
  • waxed cord or a ribbon
Trotec laser used
  • Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections


Download now

Step by step

assembly instruction for pendant
Step 1

Step 1: Design

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimised for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt the parameters and geometries.

pendant made from acylic
Step 2

Step 2: Laser Parameters

We used a Speedy 360 (60 watts power) laser machine to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: Ein - Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On

Additionally we activated the optimised geometries-function to achieve an even higher quality finish.

laser cut plexiglass pendant
Step 3

Step 3: Cleaning and assembling


To cut the stand, you can also use our template.

It may be necessary to clean the pieces and remove dust with a soft cloth. Then, simply assemble the pieces. There is no glue needed, the pieces fit together perfectly.

acrylic pendant laser cutting
Step 4

Step 4: Attach the ribbon

To assemble the piece of jewellery, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short. In the pictures below we have omitted the ribbon, so you can see the assembly better.

plexiglass for jewelry making laser
Step 5

Step 5: First side part

Insert the smallest disk onto the connector piece.

Step 6

Step 6: Insert discs

Attach all other disks to the connector part, paying particular attention to the order.

laser cut plexiglass pendant
Step 7

Step 7: Other side parts

As a final step, put the side panels around and the necklace is ready to use.

Speedy series
The ideal laser engraver and cutter for personalisation.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo