--------------------------
laserskärning av akrylhänge

Lasermade Jewelry
Necklace with Laser-Cut Pendant

Create a jewelry pendant as individual as its wearer

Förberedelse

Required material

TroLase Reverse gloss/gold 1.6mm, waxed cord or a ribbon

Trotec laser used
  • Speedy 360
  • 60 watts
  • 1.5 inch lens
Tips

Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections

pendant-JC.zip

ZIP

Ladda ner nu
csm_pendant_7688f3d5c1.png

PDF

Ladda ner nu

Steg för steg

halsband laserskuret från plexiglas
Steg 1

Step 1: Design

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimized for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries.

hänge tillverkat av acylic
Steg 2

Step 2: Laser Parameters

We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Laser Settings

Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On

Additionally we activated the optimized geometries-function to achieve an even higher quality.

Laserskuret plexiglashänge
Steg 3

Step 3: Cleaning and assembling

It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.

Tip:

To cut the stand, you can also use our template.

laserskärning av akrylhänge
Steg 4

Step 4: Attach the ribbon

To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short. 

In the pictures below we have omitted the ribbon, so you can see the assembly better.

plexiglas för smyckestillverkning laser
Steg 5

Step 5: First side part

Now insert connect one side part of the disc.

akrylhänge laserskuret
Steg 6

Step 6: Insert discs

Attach all other disks to the side part and pay attention to the order.

Laserskuret plexiglashänge
Steg 7

Step 7: Other side parts

As a final step, put the other side parts around and the necklace is ready to use.

Trotec Speedy 400 CO₂ lasergravyrmaskin med transparent lock på länkhjul

Speedy-serien
Den optimala lasergraveraren och -skäraren för personalisering.

Upptäck våra lasergraverare och laserskärare

Har du frågor om applikationer eller inställningar?
Vi hjälper gärna till med allt från Air Assist till Z-offset.

Kontakta oss
Stolt medlem av troGROUP Logo