laser cut table decoration

Table Decoration
Made of Felt

Step by step guide

Get in the mood for spring with laser cut butterfly napkin rings and flower cutlery bags!

Preparation

Required material:

4 mm polyester felt in two colors

Used Trotec Laser:

  • Speedy 400
  • 40 watts
  • 2 inch lens

Step by Step

laser cut table decoration
Spring decoration: laser cut and engraved.

Step 1: Cutting

Open the 'Spring' file in your preferred graphics software and send it to the laser using these settings (which may vary depending on your laser):

Laser Settings

Black (engraving): Power: 60%, Speed: 50%, Resolution: 500dpi, air assist ON

Red (cutting): Power: 60%, Speed 1.1%, Frequency 1000Hz, air assist ON, correction 20

napkin ring made of felt
The textile cutting edge: clean and without fringes

Step 2: Assembly

Assembling the parts is easy! The decoration has been designed to fit perfectly without the use of any adhesive.

laser cutting felt
The felt is laser engraved and cut in only one job.

Tips:

  • Use the 2 inch lens.
  • Use polyester felt. You will get a clean cutting edge and the result will be even better.
  • Using the honeycomb table prevents the felt rubbing off on the processing table. The material does not cover the whole table and the cutting gap fits exactly because there's no radiant heat from the table.
felt laser cutting
Table decoration being cut on a Speedy 400.
assembly table decoration
The assembling of the decoration is very easy.

Downloads

Template Download JobControl

Laser engraver and cutter

Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm

Product Details
See our lasers in action! Request a demo now
Request a demo now