Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
How to stop, restart or cancel your laser job
Open the JobControl laser software and click the "Start/Pause" button to stop your current job.
Press the "Start/Pause" button directly on your laser machine's control panel.
There are many advantages to pausing your current laser job. You can open the machine cover and manually adjust the laser head or axes and you can check the engraving/cutting quality. To continue the job, click or press the "Start/Pause" button again. The laser then moves to the position where the job was stopped and continues.
Go to JobControl and click on the "Stop" button in the lower right area of the screen.
Pressing the "Stop" button will cancel your laser job immediately.
Opening the cover of the laser during processing will interrupt the safety circuit and cancel the job.
A job stopped by clicking or pressing stop cannot be resumed and must be restarted from the begining.
Do you have further questions about the control and operation of your laser machine? Get in touch, our dedicated support team are happy to assist you.