GS Series

Expand your range of services with a laser system

The GS1000 enables you to create products that would be impossible without a laser system. Expand your product range with additional services such as register-accurate contour cutting, fine engraving geometries or perforation of printed materials. Short production runs become highly profitable with a GS series laser cutter.

• High return on investment even with short production runs
• Achieve extremely delicate cuts and engravings on paper

Technical data

Laser type: Galvo CO₂ laser
Work area: 19.6 x 19.6 inch
Laser power: 100 watt, super-pulsed

Download Folder

The GS1200 is an automated solution with a flat pile feeder, automated paper path and sheet stacker. The system design ensures maximum reliability and the best laser cutting quality. The feeder and paper path are equipped with, among other things, ultrasonic sensors to avoid malfunction caused by products jamming. With the patent-pending “free-floating” laser cutting method, the paper is supported laterally by brackets and are processed while free-floating by the laser. This technique is unique to the laser industry. The sheet stacker ensures that even delicately cut paper products are stacked carefully and without jamming.
Net speed: 1,800 sheets per hour

In the patent-pending laser cutting "on air" method, the paper is supported only laterally by brackets and thus lasered free-floating. As a result, the unwanted reflections of the laser beam, which have a negative impact on the cutting quality, are prevented. In addition, the cutting waste immediately falls down, allowing the final paper product to be stacked away without further action. In addition, the clamping holder ensures that the paper is always stable and thus ideally in focus. This in turn likewise ensures best cutting results and highest quality.

SpeedMark Vision uses one camera (GS1000) or two cameras (GS1200) to detect registration marks printed on the edge of the sheet of paper. These registration marks enable the SpeedMark Vision software to determine the position and rotation of the printed paper sheets on the working area of the laser. In addition, all distortions are detected and corrected by the intelligent software. This adapts the cutting path dynamically to the graphics and avoids costly missing cuts. A perfectly cut or engraved, high-quality end product is guaranteed.

The GS1000 laser workstation can be used for second-by-second laser cutting and engraving of many materials. With the CO2 laser and the large working area of up to 500 × 500 mm, a wide range of materials such as acrylic, paper, cardboard, textiles, fleece, wood, MDF, polystyrene or foam can be cut or engraved.

The GS1000 can achieve up to 50 times the speed of flatbed systems – depending on the respective application, of course. In addition, the GS1000 allows greater focus tolerance, so minor imperfections in the material will not adversely affect the engraving result. When cutting thin materials such as films, the galvo laser can likewise bring its speed advantage over flatbed lasers to bear.

Register mark detection allows printed paper to be cut delicately and engraved individually. Printing deviations are detected by the SpeedMark Vision software, and the cutting path is automatically adjusted. The cutting lines always match the printing perfectly.

For increased efficiency, a shuttle table is available for the GS100. This allows the operator to simultaneously remove the final product from the second processing table during laser processing and prepare the next product for laser processing.