- 1 sheet of LaserPaper Wood maple
- Material to cover the engraving table. Regular paper is suitable for this
Laser machine used
- Speedy 360, 120 Watt with 2" lens
- Aluminium cutting grid table or honeycomb table
To create this sample you can use any laser machine from the Speedy laser engraver series.
- For the inner part, use paper with at least 150 g/m² to secure sufficient volume of the finished item
- Make sure that "Send Beziers and paths to driver" is activated in your laser software. If this is not done then the registration marks will not be recognised by JobControl® Vision.
Step 1: Make design layout
Begin by creating your design and adapt it to your requirements. You can either print your design yourself or use your preferred printer is you don't have the facility to do so. As this tutorial uses both laser cutting and laser engraving, we put a cross hair in the middle of the print file instead of registration marks. The hair cross will help you to position the job precisely.
Send the graphic for the outer shell to your laser using the below settings:
|Process mode||Resolution||Cut line|
|Colours||enhanced geometries, inner geometries first|
Step 2: Laser cutting and engraving
Adjust the parameter settings as required. These will vary depending on the laser machine used and its available laser power.
Change the order of the colours in JobControl from red to blue so that the material is scratched first and cut second.
|Colour||Process||Power (%)||Speed (%)||ppi/Hz|
Step 3: Post-processing
Take the cover out of your laser and insert the core of the catalogue. Or if you are using a commercial printer, forward the cut-out cover to your printing representative to attach it to the catalogue.