Laser engraved brick

Create a personalised gift by simply combining a brick and laser engraving.


Required material:

  • Clay brick from any good supplier

Laser machine used:

You can use any Speedy laser engraving machine to engrave the brick.


We used the 1.5" lens because was we were engraving a detailed design. For less detailed designs you can use the 2" lens.

Step by Step

Step 1: Import design

The first step is to create your own design or import our template. Use the below parameters to send the job to the laser.

Print driver settings

Process mode Resolution Cut line
Standard 500 dpi none
Halftone Others



Step 2: Laser engraving the brick

Put the brick onto your Trotec laser engraving machine's bed and focus on the material's surface, Then create the material parameter settings. These will vary depending on laser machine and its available laser power.

Laser Parameters engraving

Colour Process Power (%) Speed (%) ppi/Hz
black engrave CO2 100 30 500
Passes Air Assist Z-Offset  Advanced
1 on +1 mm high quality



Step 3: Cleaning

Use a wet sponge to clean the surface and bind the dust. That's it, your brick is now ready to be gifted or sold.


Each brick can be personalised with names and dates.

Trotec Product recommendations

See our lasers in action! Request a demo now
Request a demo now