laser cut and engraved notebooks

Give a simple notebook
a personal touch

Step by step guide

We decorated two Leuchtturm1917® notebooks with a Speedy 400. The emerald sketchbook was enhanced with a contrasting engraving. The smaller notebook has a flexible cover was laser cut to reveal a coloured second layer.


Preparation

Required material:

  • Leuchtturm1917® Sketchbook Master (A4+), Hardcover - emerald
  • Leuchtturm1917® Jottbook Medium (A5) - navy
  • Spray glue
  • Piece of paper - the more contrasting the better

Used Trotec Laser:

  • Speedy 400
  • 80 watts
  • 2 inch lens

Step by Step

Step 1: Laser engraving the sketch book

The sketchbook was refined with a fine engraving and personalised with a name. Open the PDF design and enter your chosen name. Of course you can also use your own design.

Parameters used:

The following parameters produce a brown engraving on the emerald sketchbook: Engraving: Power: 20% - Speed: 30% - Frequency: 500 ppi - Air Assist: ON - Z-Offset: -1 mm

Note:

Note: Other colors may react differently.


Step 2: Laser cutting the notebook

The Jottbook has a flexible cover that can be easily cut with a laser. We have created a tree design for our notebook. To give more stability to the fine details, we've glued a piece of paper on the inside of the cover after the laser process.

1: table
Use the Aluminum Cutting Grid Table and cover the surface around the workpiece to focus the vacuum suction.

2: air flow shutter
If using an air flow shutter, close it to achieve optimal suction on the table and not on the exhaust slots.

3: laser process
Open the design and send it to the laser.

Parameters used:

Cutting: Power: 20% - Speed: 0.5% - Frequency: 1000 Hz - Air Assist: OFF -
Z-Offset: -1mm


Step 3: Finishing

Take a piece of paper that fits to your design and a spray glue. Glue the paper on the inside of the cover, to protect your laser cut design and give the cover more stability. Alternatively, use a glue stick, but the spray glue helps to achieve maximum coverage.