We show you how to make a personalised Christmas tree with simple cardboard.
In the PDF termplate you will find 2 versions:
Our big Christmas tree is about 1 meter high. And the small version can be used as table decoration in any size.
Big Christmas Tree:
- Required material: 5 mm corrugated cardboard
- Trotec laser used: SP500, 200 watts
Small Christmas Tree:
- Required material: 2mm corrugated cardboard
- Trotec laser used: Speedy 300, 30 watts, 2.0 inch lens
We used a SP500 to cut our Christmas tree and 5 pieces 1300 x 750 mm cardboard. You can customise the design of the tree according to your wishes - let your imagination run wild! After cutting out the parts you need to put them together. This guide shows them how to assemble the tree. Download the manual here.
Furthermore this tree can be decorated with classic Christmas balls - of course it is also very decorative without any balls or glitter.
Cutting: Power: 85% - Speed: 2% - Frequency: 1000 Hz - Air-Assist: ON - Z-Offset: -1.5mm
The tree is connected without any glue or hooks, so you can take the parts apart again and use the tree for next year.
This small Christmas tree is made of two parts, which are plugged into each other. You can choose the size of the Christmas tree as you like – for example our trees on the photo are 12 cm high.