--------------------------
  1. Trotec Laser
  2. Resurser
  3. Laserprojekt
  4. Lasercut and engraved Cardboard Chair
laserskärning av kartongmöbler

Lasercut and engraved
Cardboard Chair

Step by step guide

Förberedelse

Required material
  • 2 pieces of
    2mm corrugated cardboard
Trotec laser used
  • Speedy 300
  • 30 watts
  • 1.5 inch lens
Paper-chair-JC.zip

ZIP

Ladda ner nu
csm_Paper-chair_29c1399615.png

PDF

Ladda ner nu

Steg för steg

stol laserskuren från kartong
Steg 1

Step 1: Preparation

Use the vacuum table with the honeycomb tabletop for cutting and engraving the cardboard.

stol tillverkad av kartong laser
Steg 2

Step 2: Development

Print the first page of the PDF document (the engraving layout) in size of 610 x 300mm. Adjust the marker to the job and engrave it.
After the engraving part you have to turn around the cardboard horizontally and cut the cardboard (cutting file on the second page of the PDF document).
Then place the second cardboard sheet for cutting of the cross-brace elements in the laser. These are on the third page of the PDF document.

laserskärning av kartongmöbler
Steg 3

Step 3: Used Laser Settings

Import the PDF file into Corel Draw, customize it as you want to or take your own design and send it to the laser.

Laser Settings

Front of the first cardboard
Engraving: Power: 40% - Speed: 100% - Frequency: 500 ppi - Air Assist: OFF - Z-Offset: 6mm
 
Back of the first cardboard
Cutting-in: Power: 7% - Speed: 3% - Frequency: 1000 Hz - Air Assist: OFF - Z-Offset: 6mm
Cutting: Power: 10% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON
 
Second cardboard
Cutting: Power: 20% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON

laserskärning av kartongstol
Steg 4

Step 4: Assembly

For the assembly have a look at the installation instructions.

kartongstol laserskuren
Steg 5

Step 5: Use

Now you can use your cardboard chair for everything you want.
Make it in another scale - then you can sit on it yourself because it is so stable.
Visit kurtl.com and have a look at a range of creative furniture out of cardboard.

Open Trotec laserskärare i CO₂-serien Speedy med skärbord och kontrollpanel för bikakeskärning
Steg 6

Tips:

Use the vacuum table with the honeycumb tabletop for cutting and engraving the cardboard. You have to engrave the front of the cardboard and cut it on the back. That's why you have to turn it around after engraving and cut it on the other side.

Trotec Speedy 400 CO₂ lasergravyrmaskin med transparent lock på länkhjul

Speedy-serien
 Den optimala lasergraveraren och -skäraren för personalisering.

Upptäck våra lasergraverare och laserskärare

Har du frågor om applikationer eller inställningar?
Vi hjälper gärna till med allt från Air Assist till Z-offset.

Kontakta oss
Stolt medlem av troGROUP Logo