Laser Cut
a Paper Christmas Card

Step by step guide

Förberedelse

Required material

Paper approx. 200 g fir-tree green
Paper approx. 200 g white
Paper glue

Trotec laser used

Speedy 300
60 watts
1.5 inch lens

Christmas Card

ZIP

Ladda ner nu

ZIP

Ladda ner nu

csm_paper-christmas-card_bc16b56eb6.png

PDF

Ladda ner nu

PDF

Ladda ner nu

Steg för steg

Steg 1

Step 1:

This sample is made from two materials. We start by engraving and cutting the green paper, and then the white paper. If you like, you can add your personal inscription.

We have used the following laser parameters:

Grid engraving - power: 15 %, speed: 70 %,
resolution: 500 ppi
Vector marking – scoring: power:10 %, speed: 8 %,
resolution: 1000 Hz
Vector cut – cutting through: power: 15 %, speed: 2 %,
resolution: 1000 Hz

Steg 2

Step 2:

Once you have cut both paper sorts to size, first fold the green paper along its center folding line so that the engraving is on the inside. After that, open it again and fold it along the other folding lines (marked red in the file). You will thus obtain a three-dimensional object.

Steg 3

Step 3:

Next, apply glue thinly to the back side of the green paper and glue it to the white paper. Leave the card folded open until the glue has dried completely.

Speedy-serien
Den optimala lasergraveraren och -skäraren för personalisering.

Upptäck våra lasergraverare och laserskärare

Har du frågor om applikationer eller inställningar?
Vi hjälper gärna till med allt från Air Assist till Z-offset.

Kontakta oss