Impress your friends and colleagues with this individual paper finishing application. Precious paper laser engraved and cut.
Paper or cardboard, we used "Gmund Doubleface 925 brown, silver"
Trotec laser used
- Speedy 300
- 30 watts
- 1.5 inch lens
Step by step
Open the file "Bussines_Card" in your graphic programme, then send it to the laser. Please keep in mind that the settings for speed and laser power may vary depending on the machine used.
power: 30 %, speed: 25 %, frequency: 500 dpi, air assist: on
power: 30 %, speed: 5 %, frequency: 1000 Hz, air assist: on, Z-Offset: -2
power: 25 %, speed: 1.5 %, frequency: 1000 Hz, air assist: on
Desert blue (cutting):
power: 40 %, speed: 2 %, fequency: 1000 Hz, air assist: on
- Use the 1.5 inch lens. As a result, the detailed writings become particularly beautiful.
- If you use conventional paper and not a special cardboard, our suggestion is to reduce the laser power.
- The combination of the vacuum table and the honeycomb table leads to the best result.
- Feel free to adapt the design! Be creative!