Paper or cardboard
- We used "Gmund Doubleface 925 brown, silver"
Trotec laser used
- Speedy 300
- 30 watts
- 1.5 inch lens
Open the file "Bussines_Card" in your graphic programme, then send it to the laser. Please keep in mind that the settings for speed and laser power may vary depending on the machine used.
Power: 30%, Speed: 25%, Frequency: 500dpi, Air Assist: On
Power: 30%, Speed: 5%, Frequency: 1000Hz, Air Assist: On, Z-Offset: -2
Power: 25%, Speed: 1.5%, Frequency: 1000Hz, Air Assist: On
Desert blue (cutting):
Power: 40%, Speed: 2%, Frequency: 1000Hz, Air Assist: On
- Use the 1.5 inch lens to make the detailed writings come out particularly beautiful.
- If you use conventional paper and not a special cardboard, we suggest that you reduce the laser power.
- The combination of the vacuum table and the honeycomb table leads to the best result.
- Feel free to adapt the design! Be creative!