Die plates for
seal presses

Engrave your own custom die plates for seal presses

seal press laser engraved

Give your seals an individual touch. From letter to cards and beyond, you can use these die plates for adding personalisation to many items. In this tutorial we show you how to engrave die plates for seal presses using your Trotec laser machine. 

For more information on seal presses, visit the Trodat website.

Preparation

Materials required
  • Standard Delrin sheets for laser engraving and laser cutting out the embossing plates
  • A seal press
  • High-quality paper
Laser engraving machine used
Seal Press Plates

ZIP

Download now
Seal Press Template

PDF

Download now

Step by step

Step 1

Step 1: Laser cut and engrave the embossing plates

Begin by either creating your own design for the die plates or use our pre-prepared design. Send it to the laser using the parameters below for laser cutting and laser engraving. Depending on your laser machine and its available laser power, these parameters can vary.

RECOMMENDED PARAMETERS:

Laser engraving: Black: power 60%, speed 20%, 500 ppi, Air Assist on

Laser cutting: Red: power 50%, speed 1,0%, frequency 1000 Hz, Air Assist on

Step 2

Step 2: Glue the plate to the seal press

Take the newly made die plate out of the laser machine and thoroughly clean it. Simply wash the finished Delrin die plates with water and a little soap or dish liquid and wipe off any remaining dust with a brush. After gluing the plate to your seal press you are ready to begin embossing fine papers.

Step 3

Alternative: Engrave a text plate for a rubber stamp

You can also use the embossing plate design for engraving a text plate for a rubber stamp. We've made a separate CorelDraw file for this. Make sure to adjust your laser to the parameters below when engraving the rubber text plate.

RECOMMENDED PARAMETERS:

Engraving: Black: power 100%, speed 12%, 600 ppi, Air Assist on

Cutting: Red: power 80%, speed 0,7%, frequency 1000 Hz, Air Assist on

Speedy series
The ideal laser engraver and cutter for personalisation.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Request more
information now.

Proud member of troGROUP Logo