Trotec laser used
- Speedy 360
- 60 watts
- 1.5 inch lens
Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections
Step 1: Design
Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.
Do you want to use a different material?
Note that the cutting gap has been optimized for TroLase Reverse 1/16". When using other materials it may be necessary to adapt parameters and geometries.
Step 2: Laser Parameters
We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:
Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On
Additionally, we activated the optimized geometries function to achieve even higher quality.
Step 3: Cleaning and assembling
It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.
To cut out the stand, you can also use our template.
Step 4: Attach the ribbon
To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the excess from the ends with scissors.
In the pictures below we have omitted the ribbon, so you can see the assembly better.
Step 5: First side part
Now insert one side part of the disc.
Step 6: Insert discs
Attach all other disks to the side part and pay attention to the order.
Step 7: Other side parts
As a final step, put the other side parts around and the necklace is ready to use.