See our lasers in action!
Laser engraver and cutter
Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
| ⚫ Engrave | ⚫ Cut | ⚫ Mark |
| Laser type: | CO₂, Flexx or Fiber laser |
|---|---|
| Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
| Max. workpiece height: | 4.9 - 12.0 inch |
| Laser power: | 20 - 120 watts |
Large-format laser cutter
SP series: CO2 laser cutter for large-format materials.
| ⚫ Engrave | ⚫ Cut | ⎯ Mark |
| Laser type: | CO₂ laser |
|---|---|
| Work area: | 49.0 x 28.0 up to 87.0 x 126.4 inch |
| Max. workpiece height: | 2.0 - 4.4 inch |
| Laser power: | 40 - 400 watts |
Industrial marking laser
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
| ⚫ Engrave | ⎯ Cut | ⚫ Mark |
| Laser type: | CO₂ or Fiber laser |
|---|---|
| Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
| Max. workpiece height: | 9.8 - 30.1 inch |
| Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Table Decoration Made of Felt
Step by step guide
Get in the mood for spring by decorating your table with laser cut butterfly napkin rings and flower cutlery bags. With these cheery table top decorations, the spring mood will stay in your home... even during rainy days!
Preparation
Required material:
- 1/8" polyester felt in two colours
Used Trotec Laser:
- Speedy 400
- 40 watts
- 2 inch lens
Step by Step
Step 1:
Open the "Spring" file in your graphic program and send it to the laser. Parameters may vary depending on the machine used and the laser power available.
Laser Settings
Black (engraving):
Power: 60%, Speed: 50%, Resolution: 500dpi, air assist: ON
Red (cutting):
Power: 60%, Speed: 1.1%, Frequency: 1000Hz, air assist: ON, correction 20
Step 2:
To assemble the parts, you need just a few steps. The table decoration is designed to fit perfectly without adhesive.
Tips:
- Use the 2 inch lens.
- Our suggestion is to use polyester felt. You will get a clean cutting edge and a great engraving result.
- The use of the honeycomb table prevents the felt from rubbing off on the processing table. The material does not cover the whole table and the cutting gap fits perfectly because there is no radiant heat from the table.
