4 mm polyester felt in two colors
Used Trotec Laser
- Speedy 400
- 40 watts
- 2 inch lens
Open the file "Spring" in your favorite graphics program and send it to the laser. Laser parameters may vary depending on the machine used and the laser power available... The seetings below are for a 40W Trotec laser system.
Black Lines (engraving)
Power: 60 %, Speed: 50 %, Resolution: 500 dpi, air assist on
Red Lines (cutting):
Power: 60 %, Speed 1.1 %, Frequency 1000 Hz, air assist on, correction 20
Assemble the parts. The table decoration is designed to fit perfectly without adhesive.
- Use a 2 inch lens.
- We suggest to use polyester felt for clean cutting edges and great engraving results.
- Using a honeycomb table prevents the felt rub off on the processing table.