Heat transfer film
cut with a laser
Decorate your textiles with your favourite designs, logos and lettering "screen-printing like".
Preparation
Required material
- LaserFlex film
- T-Shirt
- heat press
Used Trotec Laser
- Speedy 300
- 60 watts
- 2 inch lens
- Vacuum table with honeycomb cutting table, aluminium cutting grid table
Step by step
Step 1
Step 1: Engrave and Cut the LaserFlex
Create your own design or use our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Recommended parameters:
Engraving: Power: 55 %, Speed: 50 %, Resolution: 500 dpi, air assist on
Cutting: Power: 12 %, Speed 1 %, Frequency 1000 Hz, air assist on
Step 2
Step 2: Finish your textile application
Use a heat press for transferring the LaserFlex on textiles. Transfer the film for 17 seconds at 165°C / 329°F. Remove the liner when the material is completely cold.