Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Some applications require a strong vacuum, while others need powerful suction through the exhaust slots. To achieve the perfect result, use the air flow shutter to control the extraction air flow.
The Trotec air flow shutter regulates the air flow between the exhaust system and the 75-mm exhaust connection on the Speedy 300, Speedy 400 or SP500 when using a vacuum table.
Adjusting the air flow shutter is easy. By reducing the air flow on this exhaust connection, the suction at the table is automatically increased, creating higher vacuum or increasing the extraction of fumes from the table, respectively.
This leads to an improved hold of films, paper and other thin materials. In addition, the cutting quality with acrylic or other plastic materials is increased as the resulting fumes are extracted immediately, leading to clear and shiny cutting edges.
Effects
Full suction at the vacuum table No extraction via the exhaust slots in the processing area
When to use
Ideal for cutting
Effects
When the air flow shutter opening is narrow, more pressure will act at the vacuum table, and less fume will be removed in the processing area.
When to use
Ideal for combining engraving and cutting with low dust generation
Effects
Suction at the table and in the processing area are normal, as if no air flow shutter were installed
When to use
Ideal in case of strong dust development, e.g. when engraving stamp rubber
Need more help?
Contact the Trotec service hotline where top qualified and motivated laser experts will assist you with any questions or problems.