Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Laser engraving prizes
Personalise awards, trophies, prizes or cases quickly and easily with Trotec laser engraving machines. Virtually any design including text, logos, images or photos can be engraved with the laser on a wide variety of materials and surface finishes in great detail. Impress clients with your own designs made of acrylic, cuts made with a Trotec laser produce a clear edge without the need for additional processing.
With the versatile Trotec laser systems, you can create valuable, individual trophies and honorary prizes as well as produce inexpensive signs for standard trophies.
When marking with CO2 lasers, it is necessary to apply a special paste or spray, which must be applied to the workpiece and dried before the laser process. The marking is burned into the metal with the laser. After the laser process, the residues of the paste or spray must be washed off. For this operation, a lot of energy is required; thus, the laser must be moved at an appropriately low speed. On some metals, high contrast can be achieved by using this process, while it should be noted that not all metals are suitable for paste or spray marking. The necessary pastes or sprays are very expensive, and the whole process is very time-consuming. Metal can be directly marked with a fiber laser. A distinction is made between engraving, annealing marking, and coating ablation. The devices of the Speedy flexx series are equipped with a CO2and a fiber laser. Use both laser sources in a single job without having to manually change the laser source, the lenses or the focus. The patented JobControl® laser software makes it possible: Simply assign the desired laser source to each color of the graphic.
Acrylic can be laser-engraved and -cut. The slightly more expensive cast acrylic (“gs”) enables crystal-clear cut edges and white engraving. However, in order to obtain a quality cut, the speed should be reduced. As a rule of thumb, a minimum of 10 W of laser power should be applied per mm of material thickness for a high-quality cut in one run. Laser cutting of extruded acrylic (“ex”) also produces crystal clear edges, but with a small burr. Extruded acrylic requires less laser power for cutting, but it is rather difficult to engrave. Acrylic is prone to flaming if the gases caused by the laser process are not removed efficiently; a high-performance exhaust system is therefore essential. Furthermore, the laser-engraving machine must never run without supervision.