1/8" polyester felt in two colours
Used Trotec Laser
- Speedy 400
- 40 watts
- 2 inch lens
Open the "Spring" file in your graphic program and send it to the laser. Parameters may vary depending on the machine used and the laser power available.
Power: 60%, Speed: 50%, Resolution: 500dpi, air assist: ON
Power: 60%, Speed: 1.1%, Frequency: 1000Hz, air assist: ON, correction 20
To assemble the parts, you need just a few steps. The table decoration is designed to fit perfectly without adhesive.
- Use the 2 inch lens.
- Our suggestion is to use polyester felt. You will get a clean cutting edge and a great engraving result.
- The use of the honeycomb table prevents the felt from rubbing off on the processing table. The material does not cover the whole table and the cutting gap fits perfectly because there is no radiant heat from the table