- 1/8" acrylics
Trotec laser used
- Speedy 300
- 60 watts
- 2.0 inch lens
- Dark coloured or radiant acrylics look very elegant
- Use a 2.0 inch lens for a perfect cut
Step 1: Cut the jewelry
Create your own design or use our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Used cutting parameters:
Power: 100%, Speed: 1%, Frequency: 5000 Hz, Air Assist: On
Step 2: Cut and engrave the jewelry stand
You can create your own or use our template for the design of the jewelry stand. Be careful, the stand has to be high enough to carry a necklace and has to have a stable pillar.
Power: 20%, Speed: 50%, Frequency: 500 ppi, Air Assist: On
Power: 100%, Speed: 0.5%, Frequency: 1000 Hz, Air Assist: On
Step 3: Assembly of the jewelry
Use eyelets and hooks to attach the pieces to a necklace. There are special hooks for the earrings, you can find them in handicraft shops, on online platforms like Amazon or in special beading shops.