Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
Max. workpiece height: | 4.9 - 12.0 inch |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 49.0 x 28.0 up to 128.0 x 126.4 inch |
Max. workpiece height: | 2.0 - 4.4 inch |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
Max. workpiece height: | 9.8 - 30.1 inch |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Step by step guide
We have designed a charming Easter decoration for you: An eggcup made from wood in the shape of an Easter Bunny. The cart is used to hold the egg. We used alder wood to make the eggcup, but it will also work with conventional plywood; ideally, use poplar plywood when laser cutting.
Use a cutting table. You can thus prevent beam reflections on the back of the material.
Open the "Easter bunny" file and send it to the laser. Start the engraving and cutting process with the power and speed parameters indicated below. (Obviously, these parameters might vary depending on what Trotec laser solution you are using and its available laser power.)
Black (engraving) - power: 25%, speed: 10%, frequency: 500dpi, Air assist on
Red (cutting) - power: 60%, speed: 1%, frequency: 1000Hz, Air assist on, correction: 10
Once you have cut out all the parts, you can assemble them. If you wish, you can also paint them before assembly.
Download: Instructions for the Easter eggcup