Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
Max. workpiece height: | 4.9 - 12.0 inch |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 49.0 x 28.0 up to 128.0 x 126.4 inch |
Max. workpiece height: | 2.0 - 4.4 inch |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
Max. workpiece height: | 9.8 - 30.1 inch |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Using your Trotec laser, you can easily create decorative wall letters for spaces such as offices, bedrooms, event venues, classrooms, and restaurants.
In the sample application described below, we used TroGlass Satins (1/8") and standoffs (product code: R15-15-FL) from Trotec.
NOTE: You can use any laser system from the Speedy series for this application.
Create your own artwork, or download our template plates (above) and adjust it to your liking. Send the file to JobControl® using the recommended Print settings below.
Process mode | Resolution | Cut line |
---|---|---|
Standard | 500dpi | none |
Halftone | Others |
---|---|
Color | Optimized Geometries, inner geometries first |
Place the first TroGlass sheet that you wish to process on the acrylic cutting grid table. Next, adjust the laser processing parameters.
Proceed to laser cut the sheet. Repeat this process for the other two TroGlass sheets.
NOTE: The optimal processing parameters may vary depending on your laser system's wattage.
Color | Process | Power (%) | Speed (%) | ppi/Hz |
---|---|---|---|---|
red | Cut CO2 | 100 | 1,2 | 5000 |
Passes | Air Assist | Z-Offset | Direction | Advanced |
---|---|---|---|---|
1 | ON | - | - | - |
Use the square TroGlass lettering cutout to mark where to drill holes in your wall. Next, use an electric drill or screwdriver to drill the mounting screws (in the standoff kit) into the marked places on your wall.
Once the holes are drilled, mount the standoffs. Finally, hang the square cutout and the lettering cutouts (in that order) on the standoffs. Finally, secure the acrylic lettering to the standoffs with an Allen key.