laser cut sports trophy from acrylic

Acrylic Sports Trophies

Would you like to make a personalized sports trophy? In this tutorial we show you how you can make a not only an impressive award, but one that stands out from the rest.


Required material

Other materials

  • Acrylic 0.118" Beige
  • 2 binding screws (shaft diameter: 1/8", length: 1.6")
  • 20 x washers (external diameter: 0.39")

Trotec laser used for this application

Speedy 400flexx, 120 watts, 2” lens

Tip: Use an acrylic cutting grid table or acrylic slat cutting table for accuracy

Step by Step

Step 1: Preparation

Choose which colours you want to use to personalize the trophies. Ensure that there’s a good amount of contrast between the individual layers of acrylic.


When ordering, ensure that the TroGlass Satins 3mm Lemon Green Translucent sheet has double-sided adhesive film on one of the sides.

Step 2: Laser Process​

Cut out the 15 elements from the acrylic sheets. We recommend using an acrylic cutting grid table for a precise cut. Cover the rest of your table and remove the protective film from the top side (adhesive).

Laser Parameters

Scoring (red):
Performance: 5%, Speed: 1%, Frequency: 1000 Hz, Air Assist: ON, Z-Offset: 4mm
Cutting (blue):
Performance: 30%, Speed: 0.2%, Frequency: 5000 Hz, Air Assist: ON

These parameters can be downloaded directly in the download section and imported into your JobControl® material database for your own use.


Select these two options in JobControl® to get perfect cutting results..

  • Optimized geometries
  • Inner geometries first

Step 3: Assembly

Compile all the cut TroGlass elements in the correct order and have the binding screws and washers ready for use.
Then attach the different parts and layers to each other by fastening the screws tightly.
Here's a short video to show how it can be done.

See our lasers in action! Request a demo now
Request a demo now