Style up your mobile phone with this exclusive phone case made from leather. Personalize the pouch with your initials for an individual touch. Check out our instructions and templates below to engrave your own phone pocket.
- 11" x 6" piece of microfiber e.g. Alcantara®
Used Trotec Laser:
- Speedy 300
- 80 watts
- 2 inch lens
Download the template file for the phone case. Open it in your preferred graphics software and change the initials to those of the person the phone pocket is for.
Send the graphic file to the laser software with the parameters recommended below. Please note that the parameters may vary depending on the machine used and the laser power available.
Engraving parameters (black graphic)
Power: 40%, Speed: 80%, Resolution: 500ppi, air assist ON
Cutting parameters (red lines)
Power: 40%, Speed: 4%, Frequency: 1000Hz, air assist ON
To finalize your engraved phone case you need to fold the two leather pieces and stitch them together along the dotted line which has been perforated by the laser. Do the same for the key chain.
- Use a 1.5 inch lens for intricate engraving details
- High laser power guarantees perfectly sealed edges