Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
Max. workpiece height: | 4.9 - 12.0 inch |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 49.0 x 28.0 up to 128.0 x 126.4 inch |
Max. workpiece height: | 2.0 - 4.4 inch |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
Max. workpiece height: | 9.8 - 30.1 inch |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Step by step instruction
Create an agate pendant with your Trotec laser machine.
For this sample you can use any laser machine from the Speedy laser engraver series.
We used the 1.5" lens for this sample because we wanted to engrave a filigree design.
Create your own design or use our file. We scanned the agate disk so that our design is exactly the right size and shape for the stone, then send the job to the laser machine with the settings below:
Process mode | Resolution | Cut line |
---|---|---|
Standard | 1000 dpi | none |
Halftone | Others |
---|---|
Color |
For the perfect result with our detailed graphics we used the highest possible resolution of 1000 dpi for our engraving job.
Place the disk in the Trotec machine and focus the laser on the surface. If the stone is round, focus on the average value of the engraving area. Make the material parameter settings. Keep in mind that the parameters can vary depending on laser machine and available laser power.
Color | Process | Power (%) | Speed (%) | ppi/Hz |
---|---|---|---|---|
black | Engrave CO2 | 50 | 30 | 1000 |
Passes | Air Assist | Z-Offset | Advanced |
---|---|---|---|
1 | on | + 1.5 mm | high quality |
Due to the +1.5 mm z-offset (out of focus) the contrast is higher than engraving in focus.
The pendant does not have to be cleaned after engraving. Add a leather band or a pin and your personalized agate pendant is ready.
Logos, aphorisms or congratulations: With a little creativity you can fulfil almost any customer's request.