See our lasers in action!
Laser engraver and cutter
Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
| ⚫ Engrave | ⚫ Cut | ⚫ Mark |
| Laser type: | CO₂, Flexx or Fiber laser |
|---|---|
| Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
| Max. workpiece height: | 4.9 - 12.0 inch |
| Laser power: | 20 - 120 watts |
Large-format laser cutter
SP series: CO2 laser cutter for large-format materials.
| ⚫ Engrave | ⚫ Cut | ⎯ Mark |
| Laser type: | CO₂ laser |
|---|---|
| Work area: | 49.0 x 28.0 up to 87.0 x 126.4 inch |
| Max. workpiece height: | 2.0 - 4.4 inch |
| Laser power: | 40 - 400 watts |
Industrial marking laser
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
| ⚫ Engrave | ⎯ Cut | ⚫ Mark |
| Laser type: | CO₂ or Fiber laser |
|---|---|
| Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
| Max. workpiece height: | 9.8 - 30.1 inch |
| Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Heat transfer film
cut with a laser
Step by step guide
Decorate your textiles with your favourite designs, logos and lettering as in screen-printing.
Preparation
Required material:
- LaserFlex film
- T-Shirt
- Heat press
Used Trotec Laser:
- Speedy 300
- 60 watts
- 2 inch lens
- Vacuum table with honeycomb cutting table
Step by Step
Step 1: Engrave and Cut the LaserFlex
Create your own design or use our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Recommended parameters:
Engraving: Power: 50%, Speed: 50%, Resolution: 500dpi, air assist on
Cutting: Power: 12%, Speed 1%, Frequency 1000Hz, air assist on
Step 2: Finish your textile application
Use a heat press for transferring the LaserFlex on textiles. Transfer the film for 17 seconds at 165°C / 329°F. Remove the liner when the material is completely cold.
