Laser cut acrylic TroGlass Satins

Easter decoration

made from Trotec Acrylic: TroGlass Satins

You need inspiration for modern Easter decoration? Here we show you how to create a colorful Easter decoration made from LaserPaper and acrylic sheets TroGlass satin. Download your graphic templates and instructions here.


Preparation

Machine used:

  • Speedy 360
  • 80 watts
  • 2" lens
  • Aluminum Cutting Grid Table or Honeycomb Cutting Tabletop for LaserPaper
  • Acrylic gutting grid for TroGlass Satins

This sample can be made on any machine from the Speedy laser engraver series.

Download:

Graphic files


Step by Step

Step 1: Import the design

Import our template and adapt it to your requirements. Send the job of the background to the laser using the driver settings below.

Tip:

Put the sheet in 0/0 position and place the job to the same position on the plate in JobControl. Due to the size the paper will not be cut.

Print settings:

Process mode: Resolution: Cut line:
Standard 500dpi none
Halftone: Others:
Color -

Step 2: Laser process LaserPaper

The laser parameters may vary depending on the type of laser machine and available laser power.

Laser Parameter Color Process Power (%)  Speed (%)  ppi/Hz
 Engraving  black  Engrave CO2  60 100 500
 Positioning  blue  Positioning  -  -  -
Passes Air Assist Z-Offset Direction Advanced
1 ON 3 top down -
- - - - -

 

 


Step 3: TroGlass Satins

Send the job for the three different TroGlass colors to the laser using the driver settings below.

Print settings:

Process mode Resolution Cut lin
Standard 500dpi none
Halftone Others
Color enhanced geometries

Step 4: Laser process TroGlass Satins

The laser parameters may vary depending on the type of laser machine and available laser power.

Laser Parameters: Cutting

Color Process Power (%) Speed (%) ppi/Hz
red Cut CO2 50 0,2 5000
Passes: Air Assist Z-Offset Direction Advanced
1 ON - - -

Step 5: Assembly

First put the LaserPaper into the picture frame. Then add the acrylic circles onto the engraved ones on the paper, smallest to smallest and so on. Make sure to align each of them to the center.

Tip:

To make the picture more stable we put the thin plasitc sheet behind the LaserPaper. And you're finished with this colourful easter decoration.


Why should I use Trotec materials?

Benefit from our laser-friendly paper and our versatile acrylic glass plates, which are especially suitable for the laser process.
Our wide TroGlass range is available in numerous colours and with different surfaces or degrees of transparency. The LaserPaper used consists of a real wood surface with a white cardboard on the back and enables extraordinary results in printing, cutting and engraving.


Inspiration

Use other colors or material combinations.


Trotec Product Recommendations