The Atmos laser exhaust system ensures safe and clean operation of your laser system. It removes dust and gas from processing space and filters odors that occur during laser processing through its activated carbon filters, resulting in the Atmos laser exhaust system facilitating the best possible laser engraving and laser cutting quality.
With Atmos exhaust systems, Trotec sets standards in user friendliness, efficiency and low laser maintenance costs.
Choosing the right exhaust system guarantees a long operation life for your laser equipment. The Atmos exhaust systems are optimally integrated with Trotec laser systems.
* Without vacuum table
** Without table exhaust
The use of a pre-filter is recommended in cases when engraving and cutting of materials produce a large amount of dust, such as e.g. wood or stamp rubber. The pre-filter is positioned between the laser machine and the exhaust system. It ensures that coarse particles and dust are separated from the exhaust air before entering the filter of the laser exhaust system. This increases the service life of your exhaust system significantly and reduces costs for replacement filters.
If particularly tenacious particles are produced, (e.g.when processing acrylic), the pre-filter can be equipped with an additive dosage unit to prolong the service life of the filter.
VENT exhaust fan for efficient removal of gas and dust
Vent series fans ensure efficient removal of dust and gases that do not require filtering. If you opt for this exhaust system, please keep in mind that it will not clean dust particles or filter odours. Should a filtering exhaust system be required at a later stage, we offer suitable exhaust systems that include a filter from the Atmos series.
The fans are designed in aluminum silicon alloy cast or steel plate and therefore ensure long-term, robust and failure-free operation.
Automatic power control: The exhaust rate is adjusted fully automatically depending on the saturation of the filter. Gas and dust are optimally extracted for all applications at any time and a constant flow of air is guaranteed.
Bi-directional control: Atmos laser exhaust systems communicate with Trotec JobControl®, SpeedMark or DirectMark laser software. The software starts automatically when the laser processing begins, and stops as soon as the job is finished. Processing notifications and warnings are displayed in the software.
Convenient filter exchange: Replacement of filter units and activated carbon is easy, clean and convenient. The innovative design allows you to replace the entire filter on your exhaust system in just a few movements.
Digital control panel: The control panel can be accessed easily and conveniently at any time. Its display shows filter saturation, air flow, operating hours and speed range.
Economic operation: The Atmos laser exhaust systems are equipped with brushless continuous flow turbines. They are completely maintenance-free. In addition, the continuous fresh air cooling ensures maximum operating life.
Energy-saving mode: The Trotec JobControl® software can be used to set the running time of the turbines before and after completing the engraving process. The exhaust power is thus adjusted reliably and saves valuable energy and money by automated switch-on times.