This unique Christmas tree is an eye-catcher for a lobby, shops or in your home. (Find engraving materials for this and other applications at: www.trotec-materials.com.)
Preparation
Required material:
3 sheets of 3mm TroGlass 1200mm x 600mm (Any color can be used. For the decoration you can use remaining material)
Each laser machine is unique, so you may have to adjust the slots to suit the lens you are using to get a nice friction fit.
Step by Step
Step 1: Import /create design template
Make your own design or import our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Print settings:
Process mode
Resolution
Cut line
Standard
500 dpi
None
Halftone
Others
Black & White
Enhanced Geometries Inner - Geometries First
Step 2: Laser process
Position the material into your laser and cover the rest of the table to increase the exhaust power. You will need 6 side parts (2 on each sheet) and 4 disks. Remove the protective foil after the cutting is complete.
Laser Parameters:
Color
Process
Power (%)
Speed (%)
ppi/Hz
red
Cutting CO2
100%
0.65
10,000
Passes
Air Assist
Z-Offset
Advanced
1
on
-
-
Info:
The material parameters of JobControl can be downloaded from www.troteclaser.com
Step 3: Post-processing
To assemble the Christmas tree, friction fit each section into the discs. Place the largest disc at the base. Note: the disc at the top of the tree is the one with two extra slots for securing the star on top of the tree.
Inspiration
Now you can put your ornaments on the tree. Or you can decorate it with individually produced TroGlass ornaments. Scroll down to the end of the page to view a large selection of designs.
