Lasermade Jewelry
Necklace with Laser-Cut Pendant

This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.

acrylic pendant laser cutting

Preparation

Required material

TroLase Reverse gloss/gold 1.6mm, waxed cord or a ribbon

Trotec laser used
  • Speedy 360
  • 60 watts
  • 1.5 inch lens
Tips

Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections

csm_pendant_7688f3d5c1.png

PDF

Download now

Step by step

necklace laser cut from plexiglass
Step 1

Step 1: Design

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimized for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries.

pendant made from acylic
Step 2

Step 2: Laser Parameters

We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Laser Settings

Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On

Additionally we activated the optimized geometries-function to achieve an even higher quality.

laser cut plexiglass pendant
Step 3

Step 3: Cleaning and assembling

It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.

Tip:

To cut the stand, you can also use our template.

acrylic pendant laser cutting
Step 4

Step 4: Attach the ribbon

To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short. 

In the pictures below we have omitted the ribbon, so you can see the assembly better.

plexiglass for jewelry making laser
Step 5

Step 5: First side part

Now insert connect one side part of the disc.

acrylic pendant laser cut
Step 6

Step 6: Insert discs

Attach all other disks to the side part and pay attention to the order.

laser cut plexiglass pendant
Step 7

Step 7: Other side parts

As a final step, put the other side parts around and the necklace is ready to use.

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo