- stamp rubber trodat, AERO+ 5mm, A4
- stamp trodat professional 5212, 116 x 70mm
- various paper bags
Step 1: Import/create laser file
Create your own design or use our free template. A tip for creating your own design: strong, not too detailed motifs and fonts are best. Avoid too fine lines - a lot of material will be removed, too thin lines can become unstable.<br/> Find more information in our tips & tricks section: stamp engraving
Now send the job to the laser with the settings below.
|Dimension||Process mode||Resolution||Cut line|
|Professional 5212 or user-defined size 116 x 70 mm||Stamp||500 dpi||optimized|
Step 2: Laser process of rubber 5mm
Make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.
Insert the laser rubber Aero+ 5 mm into the machine. Make sure that it can no longer slip, as in this process the stamp rubber is vaccuumed off after each engraving pass. A fixation can be achieved by this:
- an extraction system with good extraction performance (Atmos Duo Plus)
- Glueing the rubber plate with adhesive tape
- Use of an adhesive mat (available from Trotec)
Cover the remaining work surface to create vacuum
Laser engraving process - four passes:
Set the "Cut" to "Skip" in the parameter settings. Focus and position the laser, then start the first engraving pass. After engraving, vacuum well the dust on the rubber plate with a vacuum cleaner. Make sure that the rubber does not slip. Now repeat the engraving process three more times.<br/> Note: focus again before each pass (on the new level) and vacuum the stamp plate after each pass.
Laser process - cut:
After the engraving the cut takes place. Activate "Cut CO2"" in the parameter settings and skip "Engrave CO2".
|Color||Process||Power (%)||Speed (%)||ppi/Hz|
|Black||Engrave CO2||100||15||1000 ppi|
|Red||Cut CO2||100||0.5||1000 Hz|
|1||on, maximum air assist||-||top down||optimized quality|
Step 3: Assembly
Remove the laser rubber from the laser device and then clean it with a fine brush and water. After drying, glue the stamp plate onto the stamp.<br/> Stamp a few times on a kitchen paper. Then the stamp is ready for use!
With this stamp you can individualise your packaging quickly and easily. Your logo can be applied to paper bags, carrier bags, envelopes and cartons to further increase the visibility of your business.
As an alternative to the above-mentioned settings with four engraving passes, depth engraving can also be carried out in three passes with a resolution of 1,000 dpi, as more material is removed at higher resolutions.
However, the time required for this variant remains almost identical to the above mentioned application, as the laser needs more time for engraving with higher resolution.
Perform the laser processes as described above.
Use the following print and parameter settings for the laser process in three engraving passes.