Digital Table Exhaust

Request a demo

Digital Table Exhaust for SP2000 and SP3000

Featured on our SP3000 and SP2000 laser cutting machines, the digital table exhaust allows the operator to activate the exhaust settings in specific zones in the work area. This feature provides the best possible vacuum settings for laser cutting applications, which is a must for optimum laser cutting results. 

The digital table exhaust also increases efficiency by minimizing the need for manual setup. It is common during laser cutting applications for operators to work with materials that do not cover the entire work area. In these cases, the open areas usually need to be covered manually for an efficient vacuum. This manual setup adds time and cost to laser cutting processes.

The segmented exhaust system can divide the work area into four zones with the SP3000 and two zones with the SP2000. The segments can be individually activated by pressing a button on the operating console.

 

 

Digital Table Exhaust for SP4000

A well-thought-out exhaust system is the key for a clean and smooth cutting edge. The design of the SP4000 ensures the best extraction of dusts and gases. At the same time, the material is held down by vacuum to the laser bed to ensure process stability. The digital table exhaust can be segmented into four zones. This enables a perfect adaptation of the exhaust area to the fabric width and ensures a reliable cut even with narrow panels.

In addition to that, Trotec developed a travelling exhaust at the laser head especially for soft signage applications. It ensures efficient removal of smoke at its origin. The operator is protected and legal regulations are fulfilled – even at highest cutting speeds.