With a Trotec laser, you can create practically any design you can imagine.
Preparation
Required material
3mm acrylics, eyelets and hooks
Trotec laser used
Speedy 300
60 watts
2.0 inch lens
Tips
Dark coloured or radiant acrylics look very elegant
We used plexiglas/acrylite made by Evonik
Use a 2.0 inch lens for a perfect cut
Step by Step
Clear, flame-polished edges right out of the laser
Step 1: Cut the jewelry
Create your own design or use our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Used cutting parameters:
power 100%, speed 1.0%, frequency 5000 Hz, Air Assist on
Earrings made of radiant plexiglass shimmer in different colours
The acrylic stand stores your jewelry in a very decorative way
Step 2: Cut and engrave the jewelry stand
You can create your own or use our template for the design of the jewelry stand. Be careful, the stand has to be high enough to carry a necklace and has to have a stable pillar.
Used parameters:
Used engraving parameters: power 20%, speed 50%, 500 ppi, Air Assist on
Used cutting parameters: power 100%, speed 0,5%, frequency 1000 Hz, Air Assist on
Present your creative jewelry on the laser-cut acrylic stand
Step 3: Assembly of the jewelry
Use eylets and hooks to attach the pieces on a necklace. There are special hooks for the earrings, you can find them in handicraft shops, on online platforms like Amazon or in special beading shops.
