Get started after just half a day of training!
Learning how to operate a Trotec laser is easier than you think. In fact, half a day of training is the average time it takes to start laser cutting and engraving.
Understanding the functions of the laser control panel can take just five minutes. Explanation of the mechanical settings will also take a short period of time, however, the key portion of the instruction is the handling of the JobControl® laser software. This will only take a few hours thanks to its intuitive, user-friendly interface. The three modes of the JobControl® software are based on the needs of the user: Beginner, advanced and expert mode.
After set up of your laser is complete, initial instruction of the system can begin. During this half-day session you will learn all basic laser and software operations. With this knowledge, you can laser engrave and cut a wide variety of impressive products.