Rolling pin

This tutorial shows you how to deep engrave a rolling pin to leave fun impressions in your dough.

rolling pin laser engraving

Preparation

Required material
  • Rotary attachment
  • Wood rolling pin
  • Application tape
  • A cleaning brush and some water
Machine used
Oak Rolling Pin

ZIP

Download now
csm_Oak-Rolling-Pin_07ba6df148.png

PDF

Download now

Step by step

laser engraved rolling pin
Step 1

Step 1: Set Up Your Graphics

Be sure that when you are designing your unique graphics, the finished file is as wide as the circumference of your rolling pin and as tall as your rolling pin barrel. 

Simple geometry tips:

  • Diameter - how wide the barrel of the rolling pin is if you measured it from the two widest outside points across the barrel
  • Circumference - length if you wrapped a tape measure around the outside of the barrel (to find the circumference, take the diameter and multiply it by 3.14)

Important: If you are using text in your design, make sure that it is reversed. That is, the text needs to look backwards. This will ensure that when the text is imprinted in the dough, it will read the correct way.

laser engraved rolling pin
Step 2

Step 2: Prepare the Rolling Pin

Deep engraving requires high power from the laser machine. It is important to therefore make sure that the non-lasered parts of the barrel are clean of soot and scorching. Use application, masking or painters tape to mask the entire rolling pin. Ensure that the tape is as even and bubble-free as possible.

rotary engraving attachment laser engraver
Step 3

Step 3 - Laser Settings

Import the PDF file into Corel Draw and feel free to customise the design as you wish. Alternatively, you can create your own unique design and send it to the laser machine. Ensure that the rotary attachment has been activated and the diameter of the rolling pin has been entered in the 'properties' dialogue.

Engraving:

  • Power: 100%
  • Speed: 15%
  • Frequency: 500 ppi
  • Air Assist: ON
Step 4

Step 4 - Cleaning

Once the laser machine has finished, remove the rotary attachment and take off the application tape. It is important to inspect the rolling pin for smoke residue. We recommend thoroughly scrubbing the rolling pin with a dish brush and soap to make sure all the dust in the engraved patterns does not get in your dough. Extra smoke residue left on the barrel can be lightly sanded off if the rolling pin is unfinished.

Now it's time to bake and eat some delicious animal imprinted cookies. Enjoy!

Tips:

The attached file is for a rolling pin that is 25.4 cm long and 6.07 cm in diameter.

Speedy series
The ideal laser engraver and cutter for personalisation.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo