During the laser cutting and engraving of the stand, it is very important to ensure that the full extraction power is available at the processing table. For optimal results, cover the free processing area with paper or cardboard.
Depending on how delicate the graphics are, the cutting speed should be adjusted.
Engraving: Power: 20% - Speedy: 30% - Frequency: 500ppi – Air-Assist: ON – Z-Offset: +0,5mm
Slitting: Power: 6% - Speed: 0,6% - Frequency: 1000 Hz – Air-Assist: ON
Cutting: Power: 15% - Speed: 0,5% - Frequency: 1000 Hz – Air-Assist: ON