- Acrylic 0.118" Beige
- 2 binding screws (shaft diameter: 1/8", length: 1.6")
- 20 x washers (external diameter: 0.39")
Trotec laser used for this application
Speedy 400flexx, 120 watts, 2” lens
Tip: Use an acrylic cutting grid table or acrylic slat cutting table for accuracy
Step 1: Preparation
Choose which colours you want to use to personalize the trophies. Ensure that there’s a good amount of contrast between the individual layers of acrylic.
When ordering, ensure that the TroGlass Satins 3mm Lemon Green Translucent sheet has double-sided adhesive film on one of the sides.
Step 2: Laser Process
Cut out the 15 elements from the acrylic sheets. We recommend using an acrylic cutting grid table for a precise cut. Cover the rest of your table and remove the protective film from the top side (adhesive).
Performance: 5%, Speed: 1%, Frequency: 1000 Hz, Air Assist: ON, Z-Offset: 4mm
Performance: 30%, Speed: 0.2%, Frequency: 5000 Hz, Air Assist: ON
These parameters can be downloaded directly in the download section and imported into your JobControl® material database for your own use.
Select these two options in JobControl® to get perfect cutting results..
- Optimized geometries
- Inner geometries first
Step 3: Assembly
Compile all the cut TroGlass elements in the correct order and have the binding screws and washers ready for use.
Then attach the different parts and layers to each other by fastening the screws tightly.
Here's a short video to show how it can be done.