- masking tape
- imitation leather
- snap fastener
- snap fastener pliers
- waxed cord
Used Trotec Laser
- Speedy 300
- 80 watts
- 1.5 inch lens
- cutting table
"Tree" Design - Photo-engraving on Imitation Leather - Step 1:
The design file provided below is already prepared for the laser process. You can also use your own photo if you like. To achieve the desired effect, the image must be converted into a line-art graphic. In CorelDraw®, you can convert your graphic to line art by going to the following: Bitmap -> Mode -> Black and White. A dialog box pops up. Select the conversion "Method Line" and click OK. Further information on photo engraving.
Step 2: Laser operation
To achieve the best result, use a honeycomb cutting table. Take a piece of imitation leather, put it in the laser and smooth it down. The material may shift or distort easily during the laser process, so you should fix it in place with masking tape.
Used laser parameters
Engraving: Power: 23% - Speed: 30% - Frequency: 500ppi - Air Assist: ON - High Quality: ON
Cutting: Power: 20% - Speed: 2% - Frequency: 1000Hz - Air Assist: ON
In the download section at the bottom of this page, you can get the parameters file and import them directly to JobControl. There is a how-to for importing parameters.
Step 3: Finishing
Once you have laser-processed the imitation leather, clean it with water. There are little marks on the ends of the strap, these will help you to position the snap fasteners.
"Arrow" Design on genuine leather - Step 4: Graphics
Open our template in CorelDraw or another vector program. Of course, you can also create your own design. Let yourself be inspired by geometric patterns or floral decorations.
Step 5: Laser operation:
Take a piece of genuine leather and place it in the laser. As with the faux leather, you should fix the genuine leather in place with masking tape and use a honeycomb cutting table.
Laser Parameters used
We worked with a Speedy 300 (80 watts) and a 1.5 inch lens and used the following parameters.
Engraving: Power: 25% - Speed: 28% - Frequency: 500ppi - Air Assist: ON - Advanced: High Quality
Cutting (arrowheads): Power: 7.5% - Speed: 0.5% - Frequency: 1000Hz - Air Assist: EIN
Cutting (outline): Power: 8.5% - Speed: 0.8% - Frequency: 1000Hz - Air Assist: EIN
Step 6: Finishing
Remove any residue with a soft dry cloth. Since it is a natural material, we cannot recommend any cleaner. Aggressive cleaning agents may dry out the area or form spots on the leather. If you want to use a cleaner, please test it on an inconspicuous area or, even better, on a test strip.
Thread the waxed cord through the ends of the strap and close the bracelet with a knot.
You can find many tips and tricks for laser engraving and cutting leather below.