Leather pencil roll

Check out our roll-up pencil case selection for the very best in unique or custom, handmade pieces from our office & school supplies shops. These roll-up pencil cases offer an elegant and distinctive alternative to a conventional zipper or snap fastener case.


Required material
  • LaserLeather black/blue, 425 x 200mm 
  • 4 pens for filling the pen roll
Machine used
  • Speedy 360, 80 watts
  • 2" lens
  • Nozzle with small hole diameter
  • Vacuum table with honeycomb table support

LaserLeather can of course also be processed with another laser engraver of the Speedy series. Adjust the parameter settings according to your machine.



Download now

Step by step

Step 1

Step 1: Import/create print & laser template

Create your own design or use our template. Now send the job to the laser with the settings below.

Print settings:

Process mode: Standard
Resolution: 500dpi
Cut line: none
Halftone: Color
Others: Optimized geometries,
inner geometries first,
minimize to job size
Step 2

Step 2: Laser process

Now make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.

To process the LaserLeather, use the vacuum table with honeycomb tabletop and the nozzle with the small hole diameter. Place the LaserLeather into the laser machine. Next, cover the rest of the working surface around the material to create a vacuum.

Then start the engraving and cutting process.

Laser parameters: 

  Engrave Cut
Color Black Red
Process Engrave CO2 Cut CO2
Power (%) 60 20
Speed (%) 100 2
ppi/Hz Auto 1000
Passes 1 1
Air Assist ON ON
Z-Offset +1 -
Direction Bottom to top -
Advanced Optimized Quality -
Step 3

Step 3: Assembly

After the laser process, remove all cut parts from the laser. If necessary, clean the cut parts carefully with a lightly moistened cloth.

Insert the wide band from the bottom through the first slot so that the four small holes on the band are exactly over the four holes of the pin roll.

Now thread the narrow band through the four small holes so that the band crosses over on the upper side.

Turn the pencil roll over and knot the thin tape on the back. Then shorten the ends with scissors.

Step 4

Steps 4: Finalize the pencil roll

Place the pins one by one on the inside of the roll, and pull the wide band through the slots. Make sure the pins are fixed in the roll and tighten the tape if necessary.

Pull the ribbon through the slit at the top edge of the pencil roll.

Finally, wrap the tape once around the outside of the roll. Fix the end by pulling it once under the tape.

Why to use Trotec LaserLeather?

A two-tone artificial leather for a variety of laser applications: LaserLeather. From bags, backpacks, labels, jewelry, or, as shown here, a stylish storage option - the LaserLeather can transform into many unique pieces due to its easy processing. Intricate laser engravings and laser cuts are possible, where the second color layer can be shown and add dimension.

Make the pen roll also in other colors of the LaserLeather! By adding your name or your own design, the product can also be personalized or individualized very easily.

Develop your creativity and discover the different color combinations:

Shop LaserLeather

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo