Serviettenring mit Schnitttechnik für Biegeanwendungen

Import our graphic and adapt it to your requrements. We have already tested cutting techniques for bending applications for you. In our Tips & Tricks "Kerf Cut" you'll find further examples of how you can use this application.

Print Settings:

Place the honeycomb cutting table in your Trotec laser and attach the small nozzle to the laser head. Place the walnut plate in your laser and cover the remaining working surface. The parameters may vary depending on the laser machine used and available laser power.

Laser parameters:

We explain in our Tips & Tricks why you should choose the right nozzle for this application. How to choose the right nozzle.

Send the graphic for the TroLase Foil decoration to your Trotec Laser machine using the following print settings:

Remove the honeycomb cutting table and install the acrylic grid cutting table and the large nozzle. Insert the TroLase Foil into the laser and cover the rest of the working area.

Laserparameter:

Tip:

It is especially important to closely monitor the vacuum with the thin TroLase Foil to make sure a flat surface is maintained throughout the laser process.

Clean the two separate parts with a damp cloth. It is also a good idea to clean the back of the wooding ring so that the napkin does not get dirty later.

Keep the wooden napkin ring flat and glue the TroLase Foil about half off.

To make sure that the overhanging half does not stick to the napkin, we scored and removed half of the adhesive foil on the back with a craft knife. To finish, form a ring around a cloth napkin and secure it with the circular connector.