Engraving and deep engraving of metals

In this tutorial, we will show you how to engrave or deep engrave metals using a MOPA laser. We will also provide time-optimized and quality-optimized laser parameters for deep engraving of metals.

Laser engraving of metals

The process of engraving involves the removal of material from a solid surface. Because of the very high intensity of the laser, materials such as steel, titanium and (almost) all other metals can be vaporized directly. This is possible due to the high pulse power of the fiber laser (with Trotec up to 10 kW peak power) in combination with a very small laser spot diameter (with Trotec ~ 45 μm with the F-160 lens). With this method, texts, logos, serial numbers or other contents can be engraved into the material. The volume of the material is reduced and its color is changed. The resulting brown areas consist of metal oxides (or rust), which can be cleaned with a second cleaning cycle using polishing parameters. Engraving on stainless steel requires high power, low frequency (which results in high power per pulse) and marking speeds of 250 - 900 mm/sec.

Comparison of the deep engraving results

Deep engraving of stainless steel

The laser process for deep engraving is fundamentally identical to engraving, but with more passes. In these tips we describe two different sets of parameters:

  1. Time-optimized
  2. Quality-optimized

Please note that the set of parameters used to achieve optimal quality (2) takes about three times as long to reach the same engraving depth. A 20 watt MOPA laser with F-160 lens is used in both cases. The time-optimized engraving results are shown at the top of the image, and the quality-optimized engraving results are shown at the bottom.


1. Time-optimized laser parameters

The following parameters are used:

Power Speed Frequency Pulse duration
100% 250 mm/s 60 kHz 200 ns
Focus Filling lines distance Passes Engraving time
In focus 0.03 mm bidirectional 32 (for 200 μm depth) 112 seconds (5x5 mm square)

2. Quality-optimized laser parameters

The following parameters are used:

Power Speed Frequency Pulse duration
100% 900 mm/s 180 kHz 200 ns
Focus Filling lines distance Passes Engraving time
In focus 0.03 mm bidirectional 450 (for 200 μm depth) 375 seconds (5x5 mm square)

Multiple possibilities with deep engraving of metals

We are happy to advise you.

As you can see from this example, there are many possibilities with deep engraving of metals. Different parameters can be used depending on the requirements to be fulfilled. In the time-optimized variant, a great deal of material evaporates in a few passes (at a comparatively slow speed), and the quality-optimized variant uses significantly more (and faster) passes in order to remove the material in a more uniform and controlled manner.

Our experts from the application laboratory will be happy to consult with you regarding your requirements and they will be happy to sample your materials.

Contact Us

Dapatkan dukungan pribadi dari ahli laser kami.

Dukungan teknis
Anggota kebanggaan troGROUP Logo