Lasermade Jewelry
Necklace with Laser-Cut Pendant

This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.

acrylic pendant laser cutting

Priprema

Potrebni materijal

TroLase Reverse gloss/gold 1.6mm, voštani kabel or a ribbon

Korišteni Trotec laser
  • Speedy 360
  • 60 vata
  • 1.5 inč leća
Savjeti

Koristite saćasti stol za rezanje or an akrilni rešetkasti stol za rezanje to avoid back reflections

csm_pendant_7688f3d5c1.png

PDF

Preuzmite odmah

Korak po korak

necklace laser cut from plexiglass
Korak 1

1. korak: Dizajn

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimized for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries.

pendant made from acylic
Korak 2

2. korak: Parametri lasera

We used a Speedy 360 (60 vata power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Postavke lasera

Graviranje: Snaga: 100% - Brzina: 60% - Frekvencija: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Rezanje: Snaga: 50% - Brzina: 0.6% - Frekvencija: 2000 Hz - Air Asisst: On

Dodatnoly we activated the optimized geometries-function to achieve an even higher quality.

laser cut plexiglass pendant
Korak 3

3. korak: Čišćenje i sastavljanje

It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.

Savjet:

To cut the stand, you can also use our template.

acrylic pendant laser cutting
Korak 4

4. korak: Attach the ribbon

To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short. 

In the pictures below we have omitted the ribbon, so you can see the assembly better.

plexiglass for jewelry making laser
Korak 5

5. korak: First side part

Now insert connect one side part of the disc.

acrylic pendant laser cut
Korak 6

6. korak: Insert discs

Attach all other disks to the side part and pay attention to the order.

laser cut plexiglass pendant
Korak 7

7. korak: Other side parts

As a final step, put the other side parts around and the neckČipka is ready to use.

Serija Speedy
Savršeni stroj za lasersko graviranje i rezanje za personalizaciju.

Otkrijte strojeve za lasersko graviranje i lasersko rezanje

Imate li pitanja o primjenama ili postavkama?
Rado ćemo vas savjetovati o svim mogućim pitanjima, bilo da se radi o laserskom softveru Air Assist ili parametru z-offset.

Kontaktirajte nas
Ponosni član troGROUP Logo