acrylic pendant laser cutting

Lasermade Jewelry
Necklace with Laser-Cut Pendant

Create a jewelry pendant as individual as its wearer

This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.


Priprema

Potrebni materijal

TroLase Reverse gloss/gold 1.6mm, voštani kabel or a ribbon

Korišteni Trotec laser

  • Speedy 360
  • 60 vata
  • 1.5 inč leća

Savjeti:

Koristite saćasti stol za rezanje or an akrilni rešetkasti stol za rezanje to avoid back reflections


Korak po korak

1. korak: Dizajn

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimized for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries.


2. korak: Parametri lasera

We used a Speedy 360 (60 vata power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Postavke lasera

Graviranje: Snaga: 100% - Brzina: 60% - Frekvencija: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Rezanje: Snaga: 50% - Brzina: 0.6% - Frekvencija: 2000 Hz - Air Asisst: On

Dodatnoly we activated the optimized geometries-function to achieve an even higher quality.


3. korak: Čišćenje i sastavljanje

It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.

Savjet:

To cut the stand, you can also use our template.


4. korak: Attach the ribbon

To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short. 

In the pictures below we have omitted the ribbon, so you can see the assembly better.


5. korak: First side part

Now insert connect one side part of the disc.


6. korak: Insert discs

Attach all other disks to the side part and pay attention to the order.


7. korak: Other side parts

As a final step, put the other side parts around and the neckČipka is ready to use.


Isprobajte naše lasere u akciji! Zahtijevaj demo odmah
Zahtijevaj demo odmah