felt laser cutting for decoration

Table Decoration
Made of Felt

Step by step guide

Get in the mood for spring by decorating your table with laser cut butterfly napkin rings and flower cutlery bags. With these cheery table top decorations the spring mood will stay in your home... even during rainy days!


Required material:

4 mm polyester felt in two colors

Used Trotec Laser:

  • Speedy 400
  • 40 watts
  • 2 inch lens

Step by Step

Step 1:

Open the file „Spring“ in your graphic programme and send it to the laser. Parameters may vary depending on the machine used and the laser power available.

Laser Settings

Black (engraving):
Power: 60 %, Speed: 50 %, Resolution: 500 dpi, air assist: ON

Red (cutting):
Power: 60 %, Speed 1.1 %, Frequency 1000 Hz, air assist: ON, correction 20

Step 2:

To assemble the parts, you need just a few steps. The table decoration is designed to fit perfectly without adhesive.


  • Use the 2 inch lens.
  • Our suggestion is to use polyester felt. You will get a clean cutting edge and a great engraving result.
  • The use of the honeycomb table prevents the felt rub off on the processing table. The material does not cover all over the table and the cutting gap fits perfectly because there is no radiant heat from the table.

See our lasers in action! Request a demo now
Request a demo now