laser cut handy cover microfiber

Engraved Leather Phone Case

Step by step guide

Style up your mobile phone with this exclusive phone case made from leather. Personalize the pouch with your initials for an individual touch. Check out our instructions and templates below to engrave your own phone pocket.


Required material:

11 x 6 inch piece of microfiber e.g. Alcantara®

Used Trotec Laser:

  • Speedy 300
  • 80 watts
  • 2 inch lens

Step by Step

Step 1: Preparing the cutting file

Download the template file for the phone case. Open it in your preferred graphics software and edit the initials to those of the person the phone pocket is for.

Step 2: Laser cutting the leather

Send the graphic file to the laser software with the parameters recommended below. Please note that the parameters may vary depending on the machine used and the laser power available.

Laser Settings

Engraving parameters (black graphic)
Power: 40 %, Speed: 80 %, Resolution: 500 ppi, air assist ON

Cutting parameters (red lines)
Power: 40 %, Speed: 4 %, Frequency: 1000 Hz, air assist ON

Step 3: Assembling the parts

To finalize your engraved phone case you need to fold the two leather pieces and stitch them together along the dotted line which has been perforated by the laser. Do the same for the key chain.


  • Use a 1.5 inch lens for intricate engraving details
  • High laser power guarantees perfectly sealed edges

See our lasers in action! Request a demo now
Request a demo now