Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Create a jewelry pendant as individual as its wearer
The laser-cut pendant we're making today consists of 13 individually laser-cut and engraved pieces. The prescion of the cutting gaps enures a firm hold when assemblying, without the need for glue. By using the engraving elements, it will also allow you to create countless designs.
To avoid ''kick-backs'' or reflections, use a honeycomb cutting table or an acrylic cutting grid table.
Start the process by opening the provided PDF template and then upload the artwork to the laser. You can also create your own design and add a personal touch to the pendant.
Remember that the cutting gap has been designed specifically for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries according to the thickness of your chosen material.
We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:
Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On
Additionally we activated the optimized geometries-function to achieve an even higher quality.
In the event that you need to clean the pieces, simply remove dust with a soft cloth by gently wiping it away. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.
To cut the stand, you can also use our template.
To start assembling the piece of jewellery, start by taking the small disk with the hole. You're then going to pull the ribbon through and secure it with a knot. Cut the excess bits of ribbon off with a scissor.
In the pictures below we have edited ou the ribbon - this is just so that you can see the assembly better.
Interlock all the remaining disks to the side part. Pay careful attention to the order in which you assemble it.