Wall sticker: Butterfly

Step-by-Step instruction

Make your own decorative wall stickers using different colors of our TroLase Thins laminates.


Used material
  • 1 sheet TroLase Thins, color: Euro gold brushed/black (item no. LT754-202)
  • removeable, double-sided adhesive tape
Machine used
  • Speedy 400
  • 120 watts
  • 2" lens
  • Nozzle with large hole diameter
  • Aluminum cutting grid table or honeycomb cutting support

You can make these wall stickers with another machine from the Speedy series. To do this, you will need to scale your design accordingly, which may also require a corresponding adjustment of the cutting parameters.


The parameters we've specified refer to the butterfly in large format (engravings in grayscale, cutting lines in red). The duration for cutting the large motif is only about 3 min, and the engraving time is approximately 35 min. If you want to keep the production time of the wall sticker as short as possible, you can hide the pre-meter settings for the engraving color black. In this case, only the red cutting lines will be executed, and the time-consuming engravings are omitted. In order to make the best possible use of the large format of the material, you can add 6 smaller butterflies (level 2, blue lines) to the template. Then adjust the parameter settings for the blue cutting lines according to your quality requirements. If you prefer a full-surface gluing of the wall sticker, you can also order the TroLase Thins with self-adhesive backing.

Wall Sticker Butterfly


Download now

Step by Step

Step 1

Step 1: Import & Create Print & Laser Template

Create your own design or use our template. Now send the job to the laser with the settings below.

Print settings:

Process Resolution Cutting line
Relief 500dpi none
Raster Other
- Optimized geometries, inner geometries first
Step 2

Step 2: Laser process

Now make the parameter settings. Our suggested parameters may vary depending on the laser machine you are using and the available laser power. Remove the protective film from the surface of the TroLase Thin and then place the material - with the gold side up - on the aluminum grid table in your laser. Tape the remaining narrow edge to create the best possible vacuum.

Laser parameters:

Color Process Power (%) Speed (%) ppi/Hz
Black Engraving CO2 40 65 500
Red Cutting CO2 30 3.2 1000
Passes Air assist Z-Offset direction Path planning Advanced
1 ON +1 bottom to top - optimized quality, correction: 5
1 ON - - throughput correction: 5
Step 3

Step 3: Assembly

When you are finished processing, take the butterfly out of the laser machine. Remove the dust by carefully cleaning the wall sticker with a soft, damp cloth. Then glue some pieces of the double-sided adhesive tape onto the back of the wall sticker. Design the decoration according to your wishes.

You can make the wall sticker also in other colors of the TroLase Thins as well. Depending on the color of the material, you will need to adjust the parameter settings to suit your requirements. You can also combine the different butterflies to create a large wall decoration.

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Request more
information now.

Proud Member of troGROUP Logo